Saturday 11 November 2017

Wampler Hot Wired v.1

Original FSB thread and schematic available here.
These are 2 separate effects in one box.
Follow Mark's Dual Offboard Wiring.
23/11/2017 Layout Updated! Added the 2 Inputs caps.


12 comments:

  1. For those playing at home, this is the Brent Mason OD/Distortion. Thanks again Alex for another cool pedal to build!

    ReplyDelete
  2. can i replace 4580 for 4585 or NE5532 ?

    ReplyDelete
    Replies
    1. You should try any dual opamp with that same pinout to see what you like.
      +m

      Delete
    2. thanks, so pin 4 on 4580 datasheet is vcc- who is equals to Gnd pin 4 on NE5532 right?

      Delete
    3. Yes. Look at the 5532 data sheet also. It also says farther down that vcc- is the negative supply. In this case ground. But the can vcc- can be negative in relation to ground also but often not in guitar pedals

      http://www.ti.com/lit/ds/symlink/sa5532.pdf

      Delete
    4. Exactly. Most dual opamps can be used with "+9V/ground with reference voltage" or "+9V/-9V with ground as reference".

      Also, should be noted that most dual opamps share the same pinout.
      +m

      Delete
  3. is there a replacement for the 25k rev. pot?
    can I use a 25K lin instead?

    ReplyDelete
    Replies
    1. Yep. It's just that the taper might feel odd, but using a linear pot will be better than a log pot.

      Delete
  4. Verified! Nice distortion. Thanks Alex!

    ReplyDelete
  5. This comment has been removed by the author.

    ReplyDelete
    Replies
    1. This comment has been removed by the author.

      Delete