To add a few words, the clipping diodes are placed neatly where you can easily take them on the switch and have your way with them. I would probably go with three position two pole switch and have the middle as diode lift, other end as four 1N4148s (two in series and two of those in parallel for more volume) and other with 2 or 4 1N4001s or LEDs.
Seems i have something to do whenever i'm back in Madrid ;)
ReplyDeleteSwitch bright 1 and 3 and its good to go. I dig it.
ReplyDeleteSwapped. And tagged. Cheers onthetundra!
Delete+m
Thanks Mirosol, but I am quite sure it was a green Metal Charger. I don't have it anymore but this TSL version probably sounds better.
ReplyDeleteI want to sub the 1uf films with tantalums, instead of subbing them with ceramics. I was wondering wheret the positive side of the electro needs to be facing?Or if it even would matter?
ReplyDeleteIt matters. However. Since there is voltage on both sides of each 1µ cap, i wouldn't recommend using tantalums. Tantalums are best used in those places where the negative lead sees no voltage. There is approx. reference voltage on all those leads... If the differential between positive and negative side is not high enough, those caps won't function properly. Ceramic or polyester is the way to go with this one.
Delete+m
Awesome Thanks! I won't use them then. Can't wait to fire this one up! You Rock!
DeleteI fired it up it! Sounds great! You can sub a BF244a fet for the 2sk30. But not a 2n5457 even if you flip the source and gate.
Deleteany idea what the replacement is for D7 (w03c) on the original schematic?
ReplyDelete