Wednesday 14 April 2010

Landgraff Boost

The Landgraff Super Hard On:



Updated 24th December 2012

Mojo version for axial components and 1/2W carbon comps added



8 comments:

  1. Thanks for the update!

    Melx

    ReplyDelete
  2. It works fine! It adds nice presence to your tone, the pot is very useable for all his range. It crackles a bit just like the SHO but to my ears this one works better as presence enhancing at lower settings, if you crank it up it's very loud and it goes into distortion well, thank you for the layout.

    ReplyDelete
  3. Ultra noob question here...I built this last night and used the offboard wiring diagram from this site too. Works like a charm when the effect is engaged but when its in bypass mode the signal is muted. What's going wrong here?

    ReplyDelete
    Replies
    1. If you've wired the switch exactly as per the offboard diagram then there must be either something wrong with the switch. It can't be the input/output wiring/soldering or you'd also have the problem when the effect was turned on so that only leaves the switch.

      Delete
    2. Swapped the switch and now we're good to go! Thanks

      Delete
  4. cant find a 5.1k 1/2 watt resistor anywhere... any alternatives?

    ReplyDelete
  5. can I just use a 4.7k? its relatively close if I use a 5% carbon

    ReplyDelete