Pages

▼

Monday, 2 January 2023

Devi Ever/Dwarfcraft Devices Super Soda Meiser

This one was recently traced on FSB and as i have a soft spot for Devi & Dwarfcraft circuits alone and together, i had to draw it up.. A bit like original Soda Meiser, or at least some revisions of it, but this time with a Chaos switch and a Drone-knob.



at

12 comments:

  1. Fotocinero9 January 2023 at 10:51

    Thanks a lot for that one. I'll try to put it together soon.

    ReplyDelete
  2. Clydicus11 January 2023 at 19:57

    Verified? Hard to tell if this one is working correctly - it's a little nutty, and I don't have an original to compare it to. But my build works.

    Note: the the momentary switch connection should be normally closed

    ReplyDelete
    Replies
    1. Fotocinero16 February 2023 at 11:54

      "A little nutty" describes mine as well. Very fun build !

      Delete
    2. Martin3 April 2023 at 22:31

      Drone 3 to drone 2 or not connected?

      Delete
    3. Jayse8 August 2023 at 07:00

      Oh that is terribly annoying. Off to buy a off/on switch -_-;

      Delete
  3. Eck8 July 2023 at 00:14

    Love playing around with this pedal. I believe it is working correctly. Devi Ever pedals are a bit unusual but so much fun. Thanks for the layout. This is my first post but I have been using this site for over a year.

    ReplyDelete
  4. EMedlin30 July 2023 at 21:53

    Im extremely new at this, but where does drone 3 go?

    ReplyDelete
  5. EMedlin8 October 2023 at 14:45

    This is ape shit and i love it. Mine seems to work like the demo but is a fiddly little monster. Lots of noise variety. Has a "circuit bent" vibe.

    ReplyDelete
  6. Christos7 November 2023 at 13:04

    I'm confused on where SW1 and SW2 indicated on the tagboard actually connect to. Currently, on my 3PDT switch, (when the switch is on) I have my dry signal going to 2A, out of the switch (and into the circuit) through 1A, through the circuit, (coming out of the circuit) and into 1C, then to an amp through 2C. I get no signal when the switch is on, but my bypass when the switch is off works. I think this may have something to do with the fact that I'm ignoring the SW1 and SW2 indicators on the tagboard.

    ReplyDelete
    Replies
    1. IvIark7 November 2023 at 17:48

      The main 3PDT stomp is wired as shown in the Offboard link at the top of the page with the input going to Gain 3, and Loud 2 going to the output.

      Sw1 and Sw2 are for the momentary Chaos stomp

      Delete
  7. Grzesiek Furlaga11 August 2024 at 21:33

    Thank you for this layout. Works amazing (for noise freaks). Side note: rising Drone pot to 50k expand rangebof weirdness ( up to near tremolo territory).

    ReplyDelete