Montarbo Sinfhoton Highly Modified

Well I said that I would post a layout with a bunch of modifications to the Montarbo Sinfhoton based on what I've read people have already done. So without further a due.

Notes:

1. Removing the 100k resistor that's in series with D1 & D2 will increase the amount of fuzz, so you can lower it for more fuzz, raise it for less fuzz, or put it on a switch for 2 different settings. Hell, you can take and have 3 different settings using different combo of resistors.
2. The "Focus" switch, by putting a cap to ground at the input increases the compression of the fuzz and can provide a subtle boost in output.
3. The gain control I explained previously, but apparently putting a pot in series with the 22k or 47k resistor to ground gives a fuzz control. Johnk had used a 25k Linear pot, and raised the resistors value to 180k.
4. Notice I used the "Later Version" to make the modified layout, this is because from reading a lot of people preferred the 2uF caps being raised to 10uF like the later version. BTW, you can use 2.2uF I just wrote 2uF because that was in the original schematic.
5. As noted earlier, you may want to play with the 10k resistors to the transistor Collectors to set the bias right,
6. As far as transistors go it seems higher gain transistors, >500hfe, people seemed to prefer, but I didn't read a lot about how lower transistors sounded. To me this looks like a really stripped down and modified Big Muff, essentially just the clipping stages, I would think some of the transistor tricks for the Big Muff may work out here, but no idea.